Filter
Top Products
ATD 50 Actuator
®
Operating Instructions
Page 4
3811 N. Holton Street • Milwaukee, WI • 53212 •USA • Phone • 414-906-4000 • Fax 414-906-4100 • www.MPCovers.com
1 Explanation of symbols
This symbol warns of general hazards and of possible damage to the equipment.
This symbol warns of dangerous electrical voltages or current
2 General Safety Instructions
Before beginning installation or start-up, read and follow these
instructions. Damage to the unit and personal injury may result
from not following these instructions.
Keep fingers away from all moving parts. Be especially careful to install guards or shield
to protect personnel from the moving drive belt and pulleys.
• Be sure the electrical power is disconnected and locked-out when working
on the ATD 50 Actuator
®
.
• Install the electrical cables and power only after the mechanical installation of the
unit.
• Turn on the power to the ATD 50 Actuator
®
only after all internal cables are
connected. Do not connect cables while the unit is powered.
• Always use the correct tools for installation and repair.