Filter
Top Products
Problem Possible causes/consequences and M Solutions
The engine cannot be
started using the
SmartKey.
The on-board voltage is too low.
X
Switch off non-essential consumers, e.g. seat heating or interior
lighting, and try to start the engine again.
If this does not work:
X
Check the starter battery and charge it if necessary
(Y page 338).
or
X
Jump-start the vehicle (Y page 341).
or
X
Consult a qualified specialist workshop.
The engine cannot be
started using the
SmartKey.
The steering lock is mechanically blocked
4
.
X
Remove the SmartKey and re-insert it into the ignition lock.
While doing this, turn the steering wheel in both directions.
The engine cannot be
started using KEYLESS-
GO. The SmartKey is in
the vehicle.
A door is open. Therefore, the SmartKey cannot be detected as
easily.
X
Close the door and try to start the vehicle again.
There is interference from a powerful source of radio waves.
X
Start your vehicle with the SmartKey in the ignition lock.
4
Not vehicles with DIRECT SELECT lever.
SmartKey
83
Opening and closing
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 83
Z