Filter
Top Products
mbrace
26
Important safety notes
!
A license agreement must exist in order
to activate the mbrace service. Make sure
that your system is activated and ready for
use, and press the ï MB info call button
to register. If you cannot carry out any of
the steps mentioned, the system may not
be activated.
If you have any questions concerning
activation, please contact one of the
following service hotlines:
R
USA: Response Center under
866-990-9007
R
Canada: Customer Service under
1-888-923-8367
Shortly after successfully registering with the
mbrace service, a user ID and password will
be sent to you by post. You can use this
password to log in to the mbrace section
under "Owners Online" at http://
www.mbusa.com
27
.
The mbrace system is available if:
R
it has been activated and is operational.
Activation requires an available cellular
phone network, a valid SIM card and a
service subscription to a surveillance
service provider.
R
the battery is sufficiently charged.
R
the corresponding cellular phone network
is available for transmitting data to the
customer center.
i
Determining the location of the vehicle on
a map is only possible if there is sufficient
GPS reception and the vehicle position can
be forwarded to the customer center.
The mbrace system
The mbrace system provides three different
services:
R
automatic and manual emergency call
R
Roadside Assistance call
R
MB info call
To control the volume during an mbrace call,
proceed as follows:
X
Press the W or X button on the
multifunction steering wheel.
or
X
Use the volume controller of COMAND.
You can find information and a description of
all available features under "Owners Online"
at http://www.mbusa.com
28
System self-test
After you have switched on the ignition, the
system carries out a self-diagnosis.
G
Warning
A malfunction in the system has been
detected if any or all of the following
conditions occur:
R
The indicator lamp in the SOS button does
not come on during the system self-test.
R
The indicator lamp in Roadside Assistance
button F does not come on during the
system self-test.
R
The indicator lamp in Information button
ï does not come on during the system
self-test.
R
The indicator lamp in the SOS button,
Roadside Assistance button F, or
Information button ï remains
illuminated constantly in red after the
system self-test.
R
The message Tele Aid Inoperative or
Tele Aid Not Activated appears in the
26
The system is called TELEAID in Canada.
27
USA only.
28
USA only.
Features
295
Loading, stowing and features
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 295
Z