Filter
Top Products
Problems with Night View Assist Plus
Problem Possible causes/consequences and M Solutions
The picture quality of
Night View Assist Plus
has deteriorated.
The windshield wipers are smearing the windshield.
X
Replace the wiper blades (Y page 129).
The windshield is smeared after the vehicle has been cleaned in a
car wash.
X
Clean the windshield (Y page 316).
There is windshield chip damage in the camera's field of vision.
X
Replace the windshield.
The windshield is fogged up on the inside.
X
Defrost the windshield (Y page 142).
The windshield is iced up.
X
De-ice the windshield (Y page 141).
There is dirt on the inside of the windshield.
X
Clean the inside of the windshield (Y page 316).
Lane Tracking package
General information
The Lane Tracking package consists of Blind
Spot Assist (Y page 205) and Lane Keeping
Assist (Y page 207).
Blind Spot Assist
Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It is active at speeds above
approximately 20 mph (30 km/h). A warning
display in the exterior mirrors draws your
attention to a vehicle detected in the
monitored area. If you switch on the
corresponding turn signal before changing
lane, you will also receive visual and audible
collision warnings. For this purpose, Blind
Spot Assist uses sensors in the rear bumper.
G
Warning
Blind Spot Assist is only an aid designed to
assist driving. It may fail to detect some
vehicles and is no substitute for attentive
driving.
Blind Spot Assist cannot detect road and
traffic conditions. It may fail to detect narrow
vehicles, such as motorcycles or bicycles, or
may only detect them too late.
Monitoring may be affected by dirty sensors,
strong spray or poor visibility caused by snow,
rain or mist, for example. In this case, vehicles
are detected late or not at all.
Always pay attention to traffic conditions and
your surroundings. Otherwise, you may fail to
recognize dangers in time, cause an accident
and injure yourself and others.
i
USA only:
This device has been approved by the FCC
as a “Vehicular Radar System”. The radar
sensor is intended for use in an automotive
radar system only. Removal, tampering, or
Driving systems
205
Driving and parking
BA 212 USA, CA Edition B 2011; 1; 5, en-US
dimargi Version: 3.0.3.6
2010-05-20T13:33:46+02:00 - Seite 205
Z