Filter
Top Products
220
Controls in detail
Audio system
Calling up AUX mode
̈ Press and hold Q button until AUX
appears in the display.
The device connected with the external
audio source cinch-connector is heard,
provided it is switched to playback.
You can adjust the volume (
୴ page 216),
the sound settings (
୴ page 216) and the
volume distribution (
୴ page 218) for the
AUX input.
The following settings can be made in the
audio AUX mode:
ț Volume (୴ page 216)
ț Sound settings (୴ page 216)
ț Volume distribution (୴ page 218)
Canceling AUX mode
̈ Press any audio source button.
The AUX mode is canceled.
Warning! G
Only operate an external audio source (AUX)
when the vehicle is stationary. There is a risk
of accident by being distracted from road
and traffic conditions if you operate an ex-
ternal audio source (AUX) while the vehicle
is in motion.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your car is
covering a distance of 44 feet
(approximately 14 m) every second.
Warning! G
Due to the different volumes of the external
audio sources, system messages (e.g. traffic
and navigation announcements) may be
much louder. You may need to disable these
system messages or adjust the volume of
these messages manually.
i
Please refer to the relevant manufacturers
operating instruction for the external audio
source device.
i
The volume of external audio sources is ex-
tremely variable. It is possible that a device con-
nected as an external audio source will sound
quieter or louder in the vehicle or that the usual
maximum volume cannot be achieved. On cer-
tain devices the volume can be set separately. In
this case, start at a moderate volume and in-
crease it slowly. In this way, you can determine
whether the system is capable of playback with-
out distortion, even at high volume.