Filter
Top Products
163
Controls in detail
Loading
̈ One after the other, press the two
mounting hooks 2 inward against the
spring pressure and turn them.
The mounting hooks are locked in this
position and you can move the net into
position more easily.
̈ Turn one of the mounting hooks 2 in
the opposite direction.
The spring pressure will push it out.
̈ Engage mounting hook 2 in
holder 1.
̈ Turn the other mounting hook and en-
gage it in the opposite holder.
̈ Push both mounting hooks 2 forward
into holder 1.
Tightening partition net
Installation behind the front seats
1 Tie-down hook
2 Ring
Installation behind the rear seats
1 Tie-down hook
2 Ring
3 Tensioner
̈ Insert tie-down hook 1 in rings 2.
̈ Pull on loose ends of tie-down straps
until net is tight.
̈ After driving a short distance, check
the tension on the net and retighten if
necessary.
i
Before tightening the partition net,
remove the cargo floor plates
(
୴ page 165).