Filter
Top Products
111
Controls in detail
Lighting
Locator lighting
With the locator lighting feature activated,
the following lamps will switch on when the
vehicle is unlocked by remote control dur-
ing darkness:
ț Tail and parking lamps
ț License plate lamps
ț Side marker lamps
ț Front fog lamps
ț Additional lamps in the exterior rear
view mirrors.
The locator lighting switches off when the
driver’s door is opened.
If you do not open a door after unlocking
by remote control the lamps will switch off
automatically after of approximately
40 seconds.
̈ Turn the combination switch to
position U when exiting the vehicle
(
୴ page 107).
The locator lighting is activated.
High beam
̈ Turn the combination switch to
position õ or U (
୴ page 107).
̈ Push the combination switch in direc-
tion of arrow 1 to switch on the high
beam (
୴ page 107).
The high beam headlamp indicator
lamp A in the instrument cluster
comes on.
̈ Pull the combination switch in direction
of arrow 2 to its original position to
switch off the high beam.
The high beam indicator lamp A in
the instrument cluster goes out.
High beam flasher
̈ Pull the combination switch briefly in
direction of arrow 2 (
୴ page 107).
Fog lamps
Warning! G
In low ambient lighting or foggy conditions,
only switch from position U to õ with
the vehicle at a standstill. Switching
from U to õ will briefly switch off the
headlamps. Doing so while driving in low
ambient lighting conditions may result in an
accident.
i
Fog lamps will operate with the parking
lamps and/or low beam headlamps
on. Fog lamps should only be used in
conjunction with low beam headlamps.
Consult your State or Province Motor
Vehicle Regulations regarding permis-
sible lamp operation.