Filter
Top Products
112
Controls in detail
Lighting
Daytime running lamp mode
̈ Turn exterior lamp switch to
position M or U.
When the engine is running, the low
beam headlamps are switched on.
In low ambient light conditions, the fol-
lowing lamps will switch on additional-
ly.
ț Tail and parking lamps
ț License plate lamps
ț Side marker lamps
For nighttime driving you should turn the
exterior lamp switch to position B to
permit activation of the high beam head-
lamps.
Canada only
The daytime running lamp mode is manda-
tory and therefore in a constant mode.
Vehicles with automatic transmission*:
When the engine is running, and you shift
from a driving position to position N or P,
the low beam headlamps will switch off
with a three-minute time delay.
When the engine is running, and you
ț turn the exterior lamp switch to
position C, the parking lamps
switch on additionally.
ț turn the exterior lamp switch to
position B, the manual headlamp
mode has priority over the daytime
running.
The corresponding exterior lamps
switch on (
୴ page 110).
USA only
By default, the daytime running lamp mode
is deactivated. Activate the daytime run-
ning lamp mode using the control system,
see “Setting daytime running lamp mode
(USA only)” (
୴ page 144).
When the engine is running, and you turn
the exterior lamp switch to position C
or B, the manual headlamp mode has
priority over the daytime running lamp
mode.
The corresponding exterior lamps switch
on (
୴ page 110).
Locator lighting and night security
illumination
The locator lighting and night security illu-
mination are described in the control sys-
tem section, see “Setting locator lighting”
(
୴ page 145) and “Headlamps delayed
shut off” (
୴ page 146).
i
With the daytime running lamp mode
activated and the exterior lamp switch
in position M, the high beam head-
lamps cannot be switched on.