Filter
Top Products
Black plate (350,1)
qClock
When the ignition switch is in the ACC or
ON position, the time is displayed.
Without navigation system
Time setting
1. Press the CLK switch until a beep
sounds, and “12Hr” and “24Hr” will be
displayed.
2. Press the SET switch to switch between
“12Hr” and “24Hr” displays. The
selected display will flash.
To select the desired clock setting,
press the CLK switch again while the
preferred setting is flashing.
3. “Hr. ADJUST” will be displayed next,
and the hour portion of the display will
flash. Press the SETswitch to set the
hour, then press the CLK switch.
4. “Min. ADJUST” will be displayed
next, and the minutes portion of the
display will flash. Press the SETswitch
to set the minutes, then press the CLK
switch.
Time resetting
While the clock is displayed, press the
SET switch 1.5 seconds or more. When
the switch is released, a beep will sound
and the clock will be reset as follows:
(Example)
12:01―12:29→12:00
12:30―12:59→1:00
NOTE
When the SETswitch is released, the seconds
are reset to “00”.
With navigation system
Refer to the separate manual
“NAVIGATION SYSTEM”.
NOTE
Minutes and seconds are adjusted by the GPS,
however, it is necessary to adjust hours under
the following conditions:
l
Driving across different time zones
l
Daylight saving time start and end
qAmbient Temperature Display
When the ignition switch is in the ON
position, press the OUTSIDE switch
(page 6-6) to display the ambient
temperature.
6-124
Interior Comfort
Interior Equipment
CX-9_8V83-EA-06I_Edition3 Page350
Monday, February 26 2007 7:20 PM
Form No.8V83-EA-06I