Filter
Top Products
Black plate (106,1)
qTransmitter Maintenance
If the buttons on the transmitter are
inoperable and the operation indicator
light does not flash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
CAUTION
Ø Install the battery with the positive
pole (
) facing down. Battery
leakage could occur if it is not
installed correctly.
Ø When replacing the battery, be
careful not to bend the electrical
terminals or get oil on them. Also
be careful not to get dirt in the
transmitter as it could be
damaged.
Ø There is the danger of explosion if
the battery is not correctly
replaced.
Ø Replace only with the same type
battery (CR1620 or equivalent).
Ø Dispose of used batteries
according to the following
instructions.
Ø
Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
Ø
Never disassemble.
Ø
Never throw the battery into
fire and/or water.
Ø
Never deform or crush.
Replacing the transmitter battery
1. Unfold the key (page 3-21).
2. Insert a screwdriver into the slot and
push the tab to remove the key from
the transmitter.
Tab
3. Insert a screwdriver into the slot and
gently pry open the transmitter.
4. Remove the battery.
A
3-24
Knowing YourMazda
Doors and Locks
CX-9_8V83-EA-06I_Edition3 Page106
Monday, February 26 2007 7:17 PM
Form No.8V83-EA-06I