Filter
Top Products
Magellan NAV 6500/NAV 6510 27
Waypts
Highlight
Waypoint
Move
Move
Waypoint
ENTER
From any NAV screen, press Waypts, and use the CUR-
SOR KEY to highlight the waypoint on the map you wish
move.
Press the MOVE softkey.
As the help bar indicates, move the CURSOR KEY to the
new position on the map where you wish to move the se-
lected waypoint.
As you move the cursor to a new position, a dotted line
appears between the old location and the new. Navigation
data in the information window at left shows the bearing
and distance of the new location with respect to the old,
updating the coordinates as you move the cursor.
When you have positioned the cursor at the desired new
location, press ENTER.
A waypoint used in a route cannot be moved. The
waypoint can be moved under Route Edit.
Routes
A route is a planned course of travel defined by a series of
waypoints stored in the receiver’s memory. These waypoints
are then connected to form the segments or “legs” of the route.
There are two kinds of routes: a GOTO route and a multi-leg
route. A GOTO is a simple one-leg route, while a multi-leg
route may contain up to fifty legs.
The receiver allows you to create and store up to twenty-five
multi-leg routes, which can be activated, deactivated, viewed,
reversed, edited, copied or deleted.
Creating a GOTO Route from Waypoint List
GOTO
List
Highlight
Waypoint
ENTER
Press GOTO from any screen except the Auxiliary and full
map screens. The Map screen appears.
To select from a list of waypoints, press the List softkey.
Use the CURSOR KEY to highlight the desired destina-
tion waypoint from list and press ENTER.
Creating a GOTO route automatically deletes any
previous GOTO route. If the previous GOTO
route was a GOTO MOB, you must confirm to
delete it.