Filter
Top Products
Magellan MAP 330 GPS Receiver 3
Setting Up the MAP 330
Setting Up the MAP 330
Setting up the MAP 330 is a simple three-step process: installing the batteries,
attaching the wrist strap and initializing the MAP 330.
The MAP 330 uses two AA batteries that are installed from the back through the
battery cover. You can expect to get up to 10 hours of usage on two AA batteries
with the backlight turned off.
To remove the battery cover, turn the ring of the
battery door screw counterclockwise until the
battery cover can be removed. Insert the new
batteries as shown, making sure that the batteries
are installed with the correct polarity.
Replace the cover and tighten the battery door
screw by turning it clockwise until the battery
door is securely in place. Avoid overtightening
the battery door screw.
How much time do I have to replace the batteries? Any waypoints or
routes you have created are stored in permanent memory and should not
be lost for months with the batteries removed. Present position and time
data is not stored in permanent memory but will be held in memory for
at least two hours without batteries installed.
+
+
-
-
Always turn the MAP 330 off before removing the batteries or
turning off external power. Failure to do so can cause loss or
corruption of data.