Filter
Top Products
48
If you are satisfied with this map border and want to finish processing
it for use in your GPS unit, you can jump ahead to "Creating and Sav-
ing a Custom Map," on page 52. However, you might want to check out
the following two optional steps on estimating the size of the map, and
saving the border as a Map Border File.
Estimate Map Size (Optional)
It's a good idea to make sure your map will fit on your card, so let's
check it. Click the
ESTIMATE MAP SIZE button , on the Create
Map toolbar. After a moment it will tell you your map's file size. If it fits
the card, click
OK to clear the message and proceed to either saving the
border file or creating the map. If the map is too big, you must redraw your
map border a little smaller. Click the
DELETE MAP BORDER button , click
on any green border line or corner handle box, then re-draw a smaller bor-
der box. Use the Estimate button to re-check the size until it is correct.
Click the OK button to clear the size message box from your screen.
Saving a Map Border File (Optional)
MapCreate 6.3 gives you the option of saving your border as a Map
Border File. Saving a Map Border file is not necessary because you can
create a map without saving the border, and you can even extract bor-
ders from finished Map Files.
However, this option is useful if you like to tinker with your map bor-
ders, and you don't want to start over each time you want to change a
border. Here's how to save the border:
(Refer as needed to the "Toolbars" section, beginning on page 35.)
1. Click the
SAVE MAP BORDER button on the FILE toolbar. The Save
As dialog box appears.