Lowrance electronic 480C GPS Receiver User Manual


 
94
1. From one of the Map Pages, press
MENU| to OVERLAY DATA|ENT.
2. You'll see a list of the overlay data currently displayed. Select the
item you want to move and press
ENT||ENT.
3. The data begins to flash on your screen. Use any combination of ,
, and to move the data to a new location on the screen.
4. When satisfied, press
EXIT| EXIT.
To change displayed data font size:
1. From the Map or Sonar page, press
MENU| to OVERLAY DATA|ENT.
2. Press or to select Data Type|press
ENT, then use or to scroll
to overlay size, press
ENT. Press or to select the desired data size.
Press
ENT|EXIT|EXIT.
The selected data type will be displayed in the new size. (To change the
font size for another Data Type, repeat these steps, beginning with step
two above.)
3. To return to the previous page, press
EXIT.
NOTE:
Some data types can be displayed in only one font size. If that is the
case, the Data Size box will not be displayed for that data type.
NOTE:
The Customize command and the Overlay Data command both use
the same information categories. The difference between the two
commands is that Customize changes the data boxes on your dis-
play, and Overlay Data floats information on the display. See Cus-
tomize Page Displays, on page 77, for information on customizing
data boxes.
Pop-up Help
Help is available for virtually all of the menu labels on this unit. By
highlighting a menu item and leaving it highlighted for a few seconds, a
"pop-up" message appears that describes the function of the menu item.
This feature is on by default.
To set up Popup Help: Press
MENU|MENU| to SYSTEM SETUP|ENT|
to
POPUP HELP. With the option highlighted, press ENT to check it (turn
on) and uncheck it (turn off.) After the option is set, press
EXIT|EXIT to
return to the page display.