Filter
Top Products
ENGLISH
5
Chassis number
The chassis number is stamped on the right side of the steering head tube.
Write this number into the relevant area on page 1.
Engine number, engine type
The engine number and engine type are stamped on the right hand side of
the engine below the chain sprocket. Write this number into the relevant
area on page 1.
Clutch lever
The clutch lever 1 is located on the left side of the handlebar. The
adjusting screw
A is used to change the original position of the clutch lever
(see maintenance work on chassis and engine).
Hand decompression lever
The hand decompression lever 2 is only used in two special cases:
a)When the engine stalled.
It is possible that the starter motor is not able to crank the engine on the
next attempt. This is due to the fact that the automatic decompressor
doesn’t work properly. If this happens, pull the manual decompression
lever and start again. Afterwards normal starting will be possible.
b) When you want to push the motorcycle.
While pushing, pull the hand decompression lever to make it easier to get
the engine going.
Hand brake lever
The hand brake lever is mounted on the right side of the handle bar and
actuates the front wheel brake.
The standard position of the hand brake lever can be adjusted with the
adjusting screw (see maintenance work).
SERIAL NUMBER LOCATIONS
OPERATION INSTRUMENTS
2
1
A