Filter
Top Products
ENGLISH
28
Replacing front brake pads *
Remove the retainer 1, pull out the bolt 2 and detach the locating spring
3.
Carefully press against the brake pads with a screwdriver to move the brake
pistons into their basic position.
Remove the brake pads
4 from the brake caliper and clean the brake
caliper with compressed air.
Mount both brake pads and position the locating spring. Push the bolt all
the way in and mount the retainer.
Make sure the brake pads and the locating spring are properly mounted.
ƽ
WARNING
ƽ
–ITISVERY IMPORTANT TO KEEP THE BRAKE DISK FREE FROM OIL AND FATTY MATTERS.
O
THERWISE, THE BRAKING EFFECT WOULD BE STRONGLY REDUCED
.
–A
FTER ASSEMBLY, CHECK IF CIRCLIPS HAVE BEEN FITTED CORRECTLY.
–H
AVING PERFORMED ANY WORK ON THE BRAKING SYSTEM, ONE MUST ALWAYS
ACTUATE THE HAND BRAKE LEVER OR FOOT BRAKE LEVER
, RESPECTIVELY SO AS TO
ENSURE THAT THE BRAKE PADS WILL LIE AGAINST THE BRAKE DISK AND THE PRESSURE
POINT IS ESTABLISHED
.
Check the rear brake fluid level
The reservoir for the rear disc brake is located above the main brake
cylinder. The level of brake fluid may not fall below the „MIN” mark when
the vehicle has been left standing upright
ƽ
WARNING
ƽ
I
FTHE BRAKE FLUID LEVEL DROPS BELOW THE MINIMUM EITHER THE BRAKE SYSTEM HAS A
LEAK OR THE BRAKE PADS ARE COMPLETELY WORN
. IN THIS CASE, CONSULT AN
AUTHORIZED
KTM DEALER IMMEDIATELY.
Refilling the rear brake fluid reservoir *
When the brake fluid level has dropped to the MIN mark, you need to refill
the brake fluid reservoir.
For easier access to the brake fluid reservoir it is recommended to remove
the hexagon screw
5
. Then move the container outwards as indicated in
the illustration. Remove plug
6
with rubber boot
7
and add brake fluid
DOT 5.1 (Motorex Brake Fluid DOT 5.1) up to the „MAX“ mark. Replace
rubber boot and plug. Overflown or spilled brake liquid must be rinsed off
with water. Mount the screw and fix the brake fluid reservoir to the frame,
always making sure to prevent kinks in the connecting hose.
ƽ
WARNING
ƽ
–N
EVER USE DOT5 BRAKE FLUID! ITISBASED ON SILICONE OIL AND OF A PURPLE
COLOR
. SEALS AND BRAKE HOSES MUST BE ESPECIALLY ADAPTED TO IT.
–STORE BRAKE FLUID OUT OF REACH OF CHILDREN.
–B
RAKE FLUID CAN CAUSE SKIN IRRITATION. AVOID CONTACT WITH SKIN AND EYES. IF
YOU GET BRAKE FLUID IN YOUR EYES
, RINSE WITH PLENTY OF WATER AND CONSULT
A DOCTOR
.
!
CAUTION
!
–DON’T LET BRAKE FLUID GET IN CONTACT WITH PAINT, IT IS AN EFFECTIVE PAINT
REMOVER
.
–U
SE ONLY CLEAN BRAKE FLUID TAKEN FROM A TIGHTLY SEALED CONTAINER.
6
7
5
1
2
3
4