Filter
Top Products
ENGLISH
13
Compression damping of fork
The compression damping is to be set at the lower end of the fork tubes. It
only regulates the degree of damping during compression. Remove closing
cap
A. By using the knob 1 (COM), the degree of damping of the
compression can be adjusted. Turn the knob clockwise to increase damping,
turn it counterclockwise to reduce damping during compression.
STANDARD ADJUSTMENT:
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
WP 1418X738 ..................... 20 clicks
Rebound damping of fork
Hydraulic rebound damping determines the reaction when the fork is
rebound. By turning the knob
2, the degree of damping of the rebound
can be adjusted. Turn the knob clockwise to increase damping, turn it
counterclockwise to reduce damping during rebounding.
STANDARD ADJUSTMENT:
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
WP 1418X738 ..................... 15 clicks
Compression damping of shock absorber
With the knob 3 the degree of damping of the compression can be
adjusted. Turn the knob counterclockwise to increase damping, turn it
clockwise to reduce damping during rebounding.
STANDARD ADJUSTMENT:
WP 0118X730 ................... position 4
Rebound damping of shock absorber
With the setting wheel 4 the degree of damping of the rebound can be
adjusted. Turn the knob to the left side to increase damping, turn it to the
right side to reduce damping during rebounding.
STANDARD ADJUSTMENT:
WP 0118X730 ................... position 8
A
1
2
2
3
4