Filter
Top Products
Oregon Series Owner’s Manual 41
Appendix
1. Position the carabiner clip in the
slots on the mounting spine of the
Oregon.
Carabiner clip
Carabiner
Mounting spine
2. Slide the clip up until it locks in
place.
To remove the carabiner clip, lift
the bottom of the clip and slide the
carabiner clip off the mounting spine.
The Oregon screen does not
normally require calibration.
However, if the buttons do not seem
to be responding properly, use the
following process.
1. While the unit is turned off, press
and hold the
key for
approximately 30 seconds.
2. Follow the instructions on the
screen until “Calibration is
complete” appears.