Filter
Top Products
Receiver failed - The GPS 165 has detected a failure in the receiver hardware. If
the message persists, the GPS 165 is unusable and should be
taken to an authorized GARMIN service center.
ROM failed - The GPS 165 has detected a failure in its permanent memory. If
this message occurs, the unit is unusable and should be taken
to an authorized GARMIN service center.
Route is empty - An attempt has been made to activate an empty route.
Route is full - An attempt has been made to add more than 31 waypoints to a
route. The GPS 165 will not allow more than 31 waypoints per
route.
Route wpt deleted - One or more route waypoints were deleted.
Route wpt locked - At least one route waypoint is locked because the waypoint has
been removed from the Jeppesen NavData®, the data card is
missing, or the data card has failed.
Route truncated - The route was truncated because not enough room existed to
insert a SID, STAR or approach.
Route wpt moved - One or more route waypoints were moved at least 0.33 arc
minutes due to a database change.
SID deleted - The SID was deleted from the route because of insufficient
space in the route.
STAR deleted - The STAR was deleted from the route because of insufficient
space in the route.
Searching the sky - The GPS 165 is in the search-the-sky mode. Allow the unit to
complete data collection before turning it off.
Select auto seq mode - The GPS SEQ switch should be set to the AUTO position to
continue navigation..
Set course to ___º - The CDI/HSI should be set to the specified course.
Start altitude chng - The altitude change entered on the VNAV Planning page is
about to begin.
102
APPENDIX C
Messages
165 manual 7/13/98 4:00 PM Page 102