Filter
Top Products
Appendix A
NavData and UserData Installation and Operation
NavData® and UserData Card installation and operation
The NavData® card supplied with your GPS 165 can be installed or removed
ONLY when the GPS 165 is turned off. Insert the card with the thumb tab at the top,
and the beveled corner on the bottom right.
The UserData card can be used to make a backup of user waypoints, routes,
checklists, proximity alarms, etc. for later reference and use. The UserData card can
also be used to transfer the same information to another GPS 165.
To save the user data to the UserData card:
1. Install the UserData card.
2. Turn the GPS 165 on using
B
.
3. Use
O
to highlight ‘Save user data?’.
4. Press
E
.
The message ‘Saving to card’ is displayed while the GPS 165 transfers all user data
to the UserData card. It may take several minutes to complete the transfer. When all
user data is transferred, the GPS 165 will instruct you to turn the unit off, remove the
user card and insert the Jeppesen NavData® card. After this is complete, the GPS 165
is ready for normal operation.
94
APPENDIX A
NavData Card Operation
UserData Transfer Page.
165 manual 7/13/98 4:00 PM Page 94