Furuno 1724C Radar Detector User Manual


 
2. RADAR OPERATION
2-25
The equipment then searches for targets inside the guard zone to determine guard alarm
type. If a target is found inside the guard zone, the guard zone type becomes an “Outward
guard alarm,” and any target exiting the guard zone will trigger the audio alarm. If no target
is found, the guard zone type becomes an “Inward guard alarm,” and any targets entering
the guard zone will trigger the audio alarm. The guard alarm type is shown as G1(G2) IN or
G1(G2) OUT.
Note 1: When the radar range is less than the guard zone range “G1 (G2) IN” or “G1 (G2)
OUT” changes to “G1 (G2) ***.” The guard alarm function is not available while this
indication appears.
Note 2: If the network radar is set to standby while the guard alarm is active, the guard
alarm is cancelled. The guard alarm is redisplayed when the radar is set to transmit again.
2.22.2 When the alarm is violated…
Any radar target violating the guard zone will flash, the audio alarm sounds, and the alarm
icon appears in red. Additionally the message “TARGET ENTERED INTO
GUARD1(GUARD2)” or “TARGET LEFT FROM GUARD1(GUARD2)” is displayed at the
bottom of the screen. Press the CLEAR key to silence the alarm.
2.22.3 Cancelling the guard alarm
1. Press the ALARM key to show the ALARM menu.
2. Press the ERASE GUARD1 or ERASE GUARD2 soft key as appropriate.
3. Press the RETURN soft key to finish.
2.23 Watchman
2.23.1 How watchman works
The watchman function periodically transmits radar pulses for one minute to check for
targets in a guard zone. If a target is found in the zone, watchman is cancelled, the audio
alarm sounds and the radar continues transmitting. If no target is found the radar goes into
standby for the number of minutes specified on the RADAR DISPLAY SETUP menu. This
feature is useful when you do not need the radar’s function continuously but want to be
alerted to radar targets in a specific area. “WTCH” appears at the top left corner when
Watchman is active.
ST-BY
5,10
or
20 min
Tx
1 min
Tx
1 min
Watchman
starts
5,10
or
20 min
ST-BY
*
*
* Beeps emitted just before radar transmits.
How watchman works