Furuno 1944C-BB Radar Detector User Manual


 
7. CUSTOMIZING YOUR UNIT
7-27
Contents of GPS setup menu (con’t on previous page)
Item Description Settings
Disable Satellite
Every GPS satellite is broadcasting
abnormal satellite number(s) in its
Almanac, which contains general orbital
data about all GPS satellites, including
those which are malfunctioning. Using this
information, the GPS receiver
automatically eliminates any
malfunctioning satellite from the GPS
satellite schedule. However, the Almanac
sometimes may not contain this
information. If you hear about a
malfunctioning satellite from another
source, you can disable it manually. Enter
satellite number (two digits, max. 3
satellites),then press the C: ENTER soft
key.
Max. 3 satellites
Latitude
Sets initial latitude position after cold start.
Use the A: N < - -> S soft key to switch
coordinate.
Longitude
Sets initial longitude position after cold
start. Use the A: W < - -> E soft key to
switch coordinate.
Antenna Height
Enters the height of the GPS antenna unit
above sea surface. For further details refer
to the installation manual.
0-999 m
GPS Fix Mode
Chooses position fixing method: 2D (three
satellites in view), 2D/3D (three or four
satellites in view whichever is greater).
2D, 2D/3D
Cold Start
Clears the Almanac to receive the latest
Almanac.
No, Yes
B: GPS STATUS
(soft key)
Displays GPS satellite status display.
Requires GPS Receiver GP-310B/320B or
GPS navigator outputting the data
sentence GSA or GSV. For further details
see the chapter on Maintenance.