Fujitsu BS2000 Automobile Accessories User Manual


 
55
Mounting the Cable Management
6.1.2 Cable guide with cable clips
I The cable guide with cable clips can only be used in asymmetrical
700 mm PRIMECENTER M1 19-inch racks.
Introduction
You can use one or more cable guides with cable clips to store excess lengths
of cable in an orderly fashion at appropriate locations in the rack.
The other cable clips supplied can be distributed over the rack and mounted on
the support brackets as needed.
Performing the task
Figure 26: Mounting cable guides with cable clips
Ê Insert the cable guide with cable clips into the support upright for the cable
guide (1) at the appropriate height as shown in the figure above.
Ê Fasten the cable guide with cable clips to the rear support upright using two
screws with integrated plugwashers (2).