Filter
Top Products
17
2 Important Information
2.1 Safety Instructions
I The following safety instructions are also provided in the manual "Safety
Notes and Regulations".
V CAUTION!
Observe the safety instructions in the documentation for the individual
components mounted in the rack and the following notes on safety.
● The activities described in this manual may only be performed by
technical specialists. Ignoring the instructions in this manual can result
in personal injury or damage to equipment (risk of tipping over, etc.).
● When the unit is transported, it is only allowed to have a lean angle of
max. 10°.
● The unit must remain in the original package till its installation
location.
● Make sure the floor at the final place of installation has sufficient load-
bearing capacity.
● Always ensure that the anti-tilt plate is mounted when you set up the
PRIMECENTER M1 19-inch rack and teleskopic rails are used (risk
of tipping over).
● When connecting or disconnecting cables, refer to the relevant notes
in the section "Connecting and disconnecting cables" on page 56.
● Route the cables in such a way that they do not form a potential
hazard (make sure no one can trip over them) and that they cannot
be damaged.
● When mounting a server, pull the telescopic rails out all the way until
they click into position.
● Notice that a 42HU rack must weight at least 114 kg and a 24 HU rack
must weight at least 75 kg to fulfill the safety regulations. There is no
minimum weight for a 16HU rack.