Filter
Top Products
19
• While holding the steering column in place, position the
vehicle body upright.
• Push up on the end of the steering column to center it in
the vehicle body opening.
• Fit the steering wheel collar over the end of the steering
column and press the collar into the opening in the
vehicle body.
• Position the steering wheel upright so that the spokes
form a “Y”.
• Fit the steering wheel onto the steering column. Make
sure the base of the steering wheel fits into the steering
wheel collar.
• Fit a .354 cap nut on the end of the steering column.
• Support the end of the steering column near the steering
linkage assembly and tap the cap nut with a hammer to
secure it. Pull on the steering wheel to make sure the
cap nut is secure.
Steering
Wheel
.354 Cap Nut
Steering
Wheel
Collar
Steering
Column
28
Assembly
• Fit the steering wheel cap into the center of the
steering wheel.
• Insert two #8 x
3
/
4
" screws into the steering wheel cap.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Steering
Wheel Cap
29
“UP”