Filter
Top Products
12
8
• Place the right side of the roll cage on a flat surface with
the inside facing up.
• Insert two #8 x
3
/
4
" screws into the right roll cage.
Please Note: Eight roll cage screws have been factory
assembled.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Set the right side of the roll cage aside.
Right Roll Cage
Assembly
• Insert two #8 x
3
/
4
" screws into the inner half of the
shock set.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the other shock set
to the light rack and set the light rack assembly aside.
Light Rack
Left Inner
Shock Half
10
9
Please Note: The shock set halves and the light bar legs
are marked "L" and "R".
• Identify the inner and outer halves of each shock set.
(The outer halves have screw pegs).
• Fit the pegs on an outer shock half into the holes in a
light bar leg.
• Fit the inner shock set half against the light bar leg.
Left
Inner
Shock
Half
Left
Outer
Shock
Half
Light
Rack
Light Bar Leg
L
L
"L" Marking
Front
View
Front
View