Filter
Top Products
Door Hinge
Door Hinge
Door
Left
Roll Cage
Door
• Fit the slots on the door hinge onto the tabs on the bot-
tom of the door.
• Rotate the hinge up to enclose the cross support.
5
• Insert two #8 x
1
/2" screws through the holes in the
door hinge.
Please Note: The #8 x
3
/4" screws do not fit properly in the
door hinge. Make sure to use #8 x
1
/2" screws to complete
this assembly step.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
6
11
7
• Place the left side of the roll cage on a flat surface with
the inside facing up.
• Insert one #8 x
3
/
4
" screw into the left roll cage.
Please Note: Eight roll cage screws have been factory
assembled.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Set the left side of the roll cage aside.
Left Roll Cage
Cross
Support
Left
Roll Cage
Assembly