Filter
Top Products
Assembly
IMPORTANT! Please carefully read the owner’s information
in this manual and teach your child about proper vehicle
operation and rules for safe driving before allowing operation
of this vehicle.
•Insert the seat front tabs into the slots inside the
vehicle body.
•Then, insert the lock fastener tabs on the back of the seat
into the slots in the vehicle body.
•Using a slotted screwdriver, turn each lock fastener
1
/
4
turn
to the locked position.
IMPORTANT! Remember to keep the lock fasteners locked
at all times to prevent children from accessing the
vehicle battery compartment.
Assembly is now complete.
•Turn the vehicle body upright.
•Fit the steering wheel cap into the center of the
steering wheel.
•Insert two #6 x 1" screws through the steering wheel cap
and into the steering wheel.
•Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
41
Locked
Unlocked
•Insert a #10 x
3
/
4
" trusshead screw
through the front end of the vehicle
body and through the hole in
the bracket.
•Attach a lock nut to the end of the screw.
•While holding the locknut in place with an adjustable
wrench, tighten the screw with a Phillips screwdriver.
Do not over-tighten.
39
40
Bracket
Hole
#10 x
3
/
4
"
Trusshead
Screw
21
Steering Wheel Cap
Steering
Wheel
Seat
Lock
Fastener
Tabs
Lock Nut
Screw
Rear View
Top View
Bottom View
See
Inset
Lock Nut