Fisher-Price 73517 Motorized Toy Car User Manual


 
16
Assembly
•Slide a large washer onto the
short end of each front axle.
•Position the steering linkage
cover over the steering linkage.
Make sure the A and B
markings in the steering linkage
cover match the A and B
markings in the steering linkage. Fit the steering linkage
cover onto the front axles.
Note: The steering linkage curve should still face you.
22
Front
Axle
Front
Axle
Steering
Linkage
Cover
Large
Washer
Large
Washer
A Marking
Large
Washer
See
Inset
A Marking
A Marking
B Marking
B Marking
Steering
Linkage
Cover
•Turn the steering linkage so that
the inside (grooved side) is
facing up and the curve is
toward you.
•Position each front axle so that
the short end is facing up.
•Insert the short end of the front
axles up through the ends of
the steering linkage, as shown.
21
Short End of
Front Axle
Front
Axle
Front
Axle
Steering Linkage
Steering
Linkage
Long End of
Front Axle
Steering Linkage
Curve TOWARD You
Steering
Linkage
Curve
TOWARD
You
See
Inset
•Turn the vehicle body over so that the bottom faces you.
•Insert one #8 x
3
/
4
" screw through the front hole in the
vehicle body and into the windshield, as shown.
•Fit a small washer to two #8 x
3
/
4
" screws. Insert these
screws with washers through the other holes in the vehicle
body and into the windshield, as shown.
•Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Bottom View
20
See
Inset
See
Inset
Front Axle
Front
Hole