Filter
Top Products
15
Assembly
•Insert eight #8 x
3
/
4
" screws into the door, as shown.
•Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Turn the vehicle body
upright (or keep it on its side).
•Insert one of the tabs on the hubcap cover into a slot in
the hubcap.
•Then, push with your fingernail (or carefully with a
slotted screwdriver), the other two hubcap cover tabs into
the slots in the hubcap.
•Repeat this procedure to assemble another hubcap cover
to the other hubcap.
14
14
Hubcap
Door
Hubcap
Cover
Tab
Tab
Slots
See
Inset
•Fit the assembly tool (with lock washer in it) onto the end of
the rear axle.
•Tap the assembly tool with a hammer to secure the lock
washer on the end of the rear axle.
•Pull the wheel up to be sure it is secure on the rear axle.
•Slide the other side of the traction band around the wheel.
13
•Fit the notches on the inside of a traction band to the ridges
on a wheel, as shown.
Hint: Soak the traction band in hot water for about two
minutes to soften it.
12
Traction
Band
Wheel
Ridges
Ridges
Notches
Notches
Traction Band
Tab