Filter
Top Products
17
Assembly
•Fit a .437 white cap nut onto the end of a front axle.
•Tap the cap nut with a hammer to secure it to the end of the
front axle.
•Repeat this procedure to fasten another .437 cap nut to the
other front axle.
23
•Fit a large washer onto a front axle.
•Insert two
1
/
4
" x 1
1
/
2
" screws through the deep holes in the
steering linkage assembly and into the vehicle body.
•Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
•Pull up on the steering linkage assembly to be sure it is
secure. If it is not secure, tighten the screws a few
more turns with a Phillips screwdriver.
Bottom View
Bottom View
Bottom View
•Turn the steering assembly
over, with the smooth
side up.
•Fit the steering linkage
assembly to the front end
of the vehicle body.
IMPORTANT! Make sure the
notch on the steering linkage assembly aligns with the notch
in the front end of the vehicle body.
24
25
Notch
26
Front
Axle
White
Cap Nut
Steering Linkage
Assembly
(Smooth Side Up)
Notch
Deep
Holes
Steering
Linkage
Large
Washer
Front Axle
See
Inset