Filter
Top Products
6-21
Maintenance and Troubleshooting
Coaxial Cable at the
Electronics Housing
Disconnect the Coaxial Cable from the Electronics Housing
1. Loosen the three screws from the housing adapter.
2. Remove the adapter from the housing.
3. Loosen and remove the coaxial cable nut from the base of the
electronics housing.
Remove the Coaxial Cable
1. Remove the coaxial cable ground wire from the housing adapter
FIGURE 6-17.
Remote Electronics Exploded View.
2. Loosen the conduit adapter (or cable gland) from the
housing adapter.
Attach the Coaxial Cable
1. Route the coaxial cable through the conduit (if you are
using conduit).
2. Place a conduit adapter over the end of the coaxial cable.
3. Remove the housing adapter from the electronics housing
(if attached).
4. Slide the housing adapter over the coaxial cable.
5. Remove one of the four housing base screws.
6. Attach the coaxial cable ground wire to the housing via the
housing base ground screw.
Connect the Coaxial Cable
1. Attach and securely tighten the coaxial cable nut to the
connection on the electronics housing.
2. Align the housing adapter with the housing and attach with
three screws.
3. Tighten the conduit adapter to the housing adapter.
Ground
Connection
Housing Adapter
Housing Adapter Screws
8800-0470B01A
Electronics Housing
Conduit Adapter
Housing
Base