Filter
Top Products
Page 10 of 44
Catalog #91001, 91003, 91004, 91005, 91007, 91009
Rev. 2/06 - RS/mc
©2006 Edelbrock Corporation
Brochure #63-0282
Now select the “Download Setup” option from the “Setup Menu” and click “OK”
If the QwikData unit has any data stored in its memory, this data will be erased and the warning message “Downloading will erase all
saved data. Continue?” will be displayed.
Click on the “OK” button to proceed and the downloading progress bar will appear.
Once the download is complete, the setup information is permanently stored in the QwikData unit and you do not have to download
the setup information again unless you change the setup.
Sensor Calibration
If you are using the sensors provide in the QwikData package, then the default setup file already has all the calibration information for
the sensors. The only exception is if you want to use the drive shaft speed sensor to measure the vehicle speed (the default setup file
calibrates this sensor in RPM). The calibration of this sensor for vehicle speed will be unique for every vehicle.
To calibrate this sensor for vehicle speed, select “Digital Channels” from the “Setup” menu to display the Digital Channel Setup Screen.
Digital Sensor Calibration
QwikData configuration is performed in the “Setup” menu:
NOTE: After making any setup changes, the new setup must be downloaded to the QwikData unit using the “Download
Setup” option in the “Setup” menu before the changes are effective.