Filter
Top Products
2001 Edelbrock Corporation
Brochure No. 63-0020
©
Rev. 10/01
Page 14 of 27
2.10 Fuel Pump Installation
2.10.1 (Camaro, Firebird)
Warning: Before performing any of these steps, relieve the pressure in the fuel system.
1. Locate the fuel filter on the under-carriage of
the car. Disconnect the hard fuel line from
the filter.
2. Install the male O-Ring to –6AN male adapter
fitting into the outlet of the fuel filter.
3. Mount the fuel pump to the under-carriage of
the vehicle. Cut the supplied fuel line to size
as pictured.
4. Install the hose fittings and tighten all hoses
down with the supplied hose clamps.
5. Install the female O-Ring to –6AN male
adapter to the end of the steel fuel line.
Secure fitting to hose with supplied hose
clamp and connect hard fuel line to this fitting.
Check the fuel system for leaks by turning the
ignition key to the “On” position. Inspect all
fittings and lines for leaks.
2.10.2 (Impala)
Warning: Before performing any of these steps, relieve the pressure in the fuel system.
1. Locate the fuel lines under the vehicle. These should be 2 black plastic lines located on the
driver’s side of the vehicle by the frame rails. Determine which line is the main feed line by
following them back to the fuel filter.
2. Determine the mounting location of the fuel pump and mount the pump. Be sure the pump will be
mounted above the lowest parts of the car and out of danger from road debris. The pump must
be mounted between the fuel filter and engine.
3. Cut the plastic fuel line using a sharp razor blade or other similar cutting tool. Be sure where you
decide to cut the line is close to the booster pump.
4. Install the supplied compression fitting adapters to the cut plastic fuel line. Using the supplied fuel
line, cut lengths that will reach from the booster pump to the hose barbs on the compression
fittings.
5. Install cut fuel lines and secure using the supplied hose clamps.
6. Check the fuel system for leaks by turning the key to the “On” position. Inspect all fittings and
lines for leaks.