Filter
Top Products
8
© 2008 Directed Electronics. All rights reserved.
Installation points to remember
This product is designed for fuel-injected, automatic transmission vehicles only.
Installing it in a standard transmission vehicle is dangerous and is contrary to
its intended use.
➤ Intelli-Tach
Intelli-Tach is a new feature for Ungo this year. It is the default RPM-sensing
method for the new remote start system.
Intelli-Tach gives the installer the performance of a hard wired tach wire, with
the convenience of voltage sensing. It is far superior to any voltage-sense feature
you’ve tried before.
Intelli-Tach monitors the cranking voltage of the vehicle using a very fast micro
controller and an analog-to-digital converter. The microprocessor “saves” the
base voltage as a reference. When Intelli-Tach “sees” the slightest uptick in
voltage, indicating that the alternator is charging the battery, the starter motor
shuts off instantly.
➤ D2D
The system has the ability to interface with an XK module through the D2D port.
The advantage to using a D2D interface is that there is less wiring involved in
the installation. Check the XK module installation guide to determine which wires
are not needed, and which options are available.