Filter
Top Products
22
© 2008 Directed Electronics. All rights reserved.
Connect this wire to the provided toggle (override) switch as shown in figure
A. Connect the other wire from the toggle switch to the park/neutral switch in
the vehicle. This wire will test with ground with the gear selector either in PARK
or NEUTRAL. This will prevent the vehicle from accidentally being started while
in a drive gear. This input MUST rest at ground in order for the remote start
system to operate. Connected properly the vehicle will only start while in PARK
or NEUTRAL.
In some vehicles, the park/neutral position switch activates a factory starter lock
out that will not allow the starter to operate in a drive gear. In these vehicles,
connect this wire to the toggle switch as shown in figure B. Connect the other
wire from the toggle switch to chassis ground.
Important: Always perform the Safety Check section of this installation guide to
verify that the vehicle cannot be started in ANY drive gear and that the override
switch is functioning properly.
Figure A Figure B
H2/2
VIOLET/WHITE TACHOMETER INPUT
This input provides the module with information about the engine's revolutions
per minute (RPMs). It can be connected to the negative side of the coil in vehicles
with conventional coils. In multi-coil and high energy ignition systems locating a
proper signal may be more difficult. Once connected, you must teach the system
the tach signal. (See the Internal Programming Jumpers section of this guide.