Filter
Top Products
23
© 2008 Directed Electronics. All rights reserved.
H2/3
BROWN (+) BRAKE SWITCH INPUT, ZONE 1
This wire MUST be connected to the vehicle’s brake light wire. This is the wire
that shows (+) 12V when the brake pedal is depressed. The remote start will be
disabled or shut down any time the brake pedal is depressed.
H2/4
GRAY (-) HOOD PIN SWITCH INPUT, ZONE 1
This wire MUST be connected to a hoodpin switch. This input will disable or shut
down the remote start when the hood is opened. .
H2/5
BLUE/WHITE (-) STATUS OUTPUT
This wire supplies a 200mA output as soon as the module begins the remote
start process. The H2/5 Blue/White wire can also be used to activate the
defogger trigger (latched/pulsed), 10-seconds after the remote start engages.
(See the Feature Descriptions section in this guide for details about programming
this output.)