Filter
Top Products
21
© 2008 Directed Electronics. All rights reserved.
H1/9
WHITE (+/-) LIGHT FLASH OUTPUT
Important:
Do NOT connect this wire to a negative vehicle
light flash wire before changing the programming jumper to
the negative polarity position or damage to the vehicle light
circuit may occur.
As factory configured, the H1/9 WHITE wire should be connected to the (+)
parking light wire. If the light flash polarity jumper is moved to the (-) position
(refer to the Programming Jumper section of this guide), this wire then supplies
(-) 200mA output.
(+) Positive Light Flash Output
(-) Negative Light Flash Output
WHITE H1/11
(+) LIGHT FLASH OUTPUT
WHITE H1/11
(-) LIGHT FLASH OUTPUT
Note: For parking light circuits that draw 10-amps or more, the internal jumper
must be switched to a (-) light flash output. (See Setting the light flash polarity
section of this guide.) P/N 8617 or a standard automotive SPDT relay must be
used on the H1/2 light flash output harness wire.
➤ Remote start harness, (H2) 5-pin connector
H2/1
BLACK/WHITE NEUTRAL SAFETY SWITCH INPUT