Directed Electronics 417 Automobile Alarm User Manual


 
© 2000 Directed Electronics, Inc. Vista, CA 7
This system has Remote Valet, so the user can enter and exit Valet Mode without having to reach the
Valet/program switch. DEI introduced this feature so that switch location was less critical in day-to-day use. As
long as the Valet/program switch can be reached to disarm without a transmitter, easy access is not important.
IMPORTANT! When the vehicle is delivered, please show the user where the switch is located and
how to disarm the system with it.
Things to remember when positioning the Status LED:
It should be visible from both sides and the rear of the vehicle, if possible.
It needs at least
1
/2-inch clearance to the rear.
It is easiest to use a small removable panel, such as a switch blank or a dash bezel. Remove it before drilling
your
9
/32-inch hole.
Use quick-disconnects near the LED wires if the panel is removable. This allows mechanics or other installers
to remove the panel without cutting the wires.
locations for the status LED