Filter
Top Products
© 2000 Directed Electronics, Inc. Vista, CA 15
H1/6 BLUE (-) INSTANT TRIGGER, ZONE 1
This input will respond to a negative input with an instant trigger. It is ideal for hood and trunk pins or vehi-
cles without factory Content Theft Deterrent (CTD). Vehicles without CTD may require trunk pins or need to be
hard-wired to the alarm. (A trunk pin wire may need to be added if the vehicle does not already have a factory
trunk pin.) The H1/6 BLUE wire will report on Zone 1.
NOTE: Factory CTD systems in Bonnevilles, Auroras and LeSabres do not monitor the trunk pin wire.
For Level I security mode, the H1/6 BLUE wire must be hard-wired to the vehicle’s factory trunk pin
wire. This step is not required if Level II security mode is selected.
H1/8 BLACK (-) CHASSIS GROUND CONNECTION
Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than your own screw.
(Screws tend to either strip or loosen with time.) We recommend grounding all your components, including the
siren, to the same point in the vehicle.
H1/9 YELLOW (+) IGNITION INPUT
Connect this wire to the (+)12V ignition wire. This wire must show (+)12V with the key in run position and during
cranking. Take care to insure that this wire cannot be shorted to the chassis at any point.