Filter
Top Products
© 2000 Directed Electronics, Inc. Vista, CA 13
IMPORTANT! Never interrupt any wire other than the starter wire.
NOTE: If connecting the H1/1 wire to control another module, such as a window controller (P/N
529T or 530T), a 1 amp diode (type 1N4004) will be required. Insert the diode as shown in the
following diagram.
H1/2 WHITE (-/+) SELECTABLE LIGHT FLASH OUTPUT
As shipped, with the light flash polarity jumper inside the unit in its default position (see the Internal
Programming Jumpers section of this guide), this wire supplies a (-) 200 mA output, which is suitable for driving
a negative (-) parking light relay.
If the light flash polarity jumper inside the unit is moved to the opposite positive (+) position (see the Internal
Programming Jumpers section of this guide), this wire supplies a (+) 200 mA output, which is suitable for driving
(+) parking light wires.