Clifford ACE 7500 Remote Starter User Manual


 
Con trol Unit and Extended Range Re ceiver
The ACE 7500 con trol unit must be in stalled in side the ve hi cle, never un der
the hood or other simi larly hos tile en vi ron ment.
1. Select a mounting area, but do not affix the control unit until wiring and testing is complete.
2. Plug the 18” CliffNet DataPort Extension Cable into the control unit. Make sure the
receptacle end will be accessible after the dash has been put back. This eases later service.
3. Plug the extended range receiver in to the system and mount it away from the control unit.
4. Run the antenna rod up the window pillar and affix it to the windshield about an inch from
the roofline. Do not fold the excess cable or antenna wire. Do not make hard, sharp bends.
5