Clifford ACE 7500 Remote Starter User Manual


 
Pro gram ming the User- Selectable Fea tures
1. Write down the column (across) number and row (down) number of the feature(s) you
wish to program.
2. Turn the ignition to the “ON” position or start the engine.
3. Enter the factory preset valet/programming code of “2” by pressing the PlainView 2
Switch’s button two times, then press the blank button.
4. After entering the code, press and hold the for about 3 seconds until you hear one siren
chirp and the LED turns on to confirm the system is in the “Feature Select” position.
5. Select the feature column: Press the blank PlainView 2 switch button the number of times
indicated for that column. Pause. You will then hear the same number of chirps as the
column number you have selected, audibly confirming your selection.
6. Within five seconds, select the feature row: Press the button the number of times
indicated for that row. You’ll hear a chirp each time you press the button to help you
count.
7. If there is a NOTE for the selected feature, perform the actions noted.
8. Pause. You will hear either one or two chirps: two chirps = ON, one chirp = OFF.
9. You can select another feature, or you can exit program mode:
a. To select another feature in that same column, repeat step 6 within the next five
seconds (after five seconds, three chirps indicate that the ACE 7500 is now back in the
Feature Select position).
b.To select a different feature column, repeat step 5.
c. To exit program mode, turn the ignition off (you’ll hear three chirps and the LED will
turn off to indicate exit of program mode), or wait 60 seconds and the ACE 7500 will
automatically exit program mode.
User- Programmable Fea tures
User- Programmable Fea tures (1 Chirp = OFF, 2 Chirps = ON)
Fea ture
Select
Blank x 1 Blank x 2 Blank x 3 Blank x 4
x 1
AutoProgram
New Master
Remote
NOTE 1
Chirps
(Off/On)
(1/2 chirps)
AutoArming
(Off/On)
(1 chirp/2 chirps)
Arm/Disarm
w/Secondary Remote
NOTE 5
x 2 NOT USED
Headlight
Reminder
(Off/ On)
AutoArm & Lock
(Off/On)
Auxiliary A Accessory
w/Secondary Remote
NOTE 6
x 3
Siren Sounds*
(Always /Trigger)
(1/2chirps)
Remote Valet
Feature
(Off/On)
Entry Delay
(Off/On )
Silent Arm/Disarm
w/Secondary Remote
NOTE 6
x 4
Si ren Du ra tion
(30 /60/90 sec)
(1/2/3 chirps)
AutoStart
(Neither/Battery/
Temperature/Both)
(1/2/3/4 chirps)
FACT
(Off/On)
Manual Start Enable
w/Secondary Remote
NOTE 6
x 5
AutoLock
(Off/Instant/RPM)
(1/2/3 chirps)
BlackJax
(Off/On)
Delayed
Accessory Power
(Off/On )
Remote Start
w/Secondary Remote
NOTE 6
x 6
AutoUnlock
(Off/On)
Clear All Remotes
NOTE 3
NOT USED
SmartWindows 4
w/Secondary Remote
NOTE 6
x 7
Re set All to
Fac tory Set tings
NOTE 2
Valet Code
NOTE 4
NOT USED
Remote Valet Mode
w/Secondary Remote
NOTE 6
*Re quires Self- Powered Smart Si ren 4
16