Filter
Top Products
Certificate of Installation
After installation and testing has been completed, you must fill in the Clifford Electronics Certificate of Installation .
Programmable Features
IntelliGuard 6000 comes from the factory with its features preprogrammed as noted in bold text in the tables on pages 8 and 9. Some
features can be programmed by the installer or the user, others can only be programmed by the insta ller. There are two tables
provided which define the user-programmable and installer-programmable features.
Using the CliffNet Wizard Pro
The CliffNet Wizard Pro provides intuitive access to all installer and user-programmable features t hrough a user-friendly, graphical
user interface. Because CliffNet Wizard Pro is Windows™-compatible, most operations can be accompl ished by simply pointing and
clicking a mouse. CliffNet Wizard Pro totally eliminates complicated programming charts and length y programming sequences.
Please refer to the CliffNet Wizard Pro User’s Guide for more programming information if you are using the CliffNet Wizard Pro.
Otherwise, for manual programming refer to the tables provided in the following sections.
Programming the User-Selectable Features
1. Write down the column (across) number and row (down) number of the feature(s) you wish to program.
2. Turn the ignition to the “ON” position or start the engine.
3.Enter the factory preset valet/programming code of “2” by pressing the PlainView 2 Switch’s
✱ button twice, then press the
unmarked button.
4.After entering the code, press and hold the
✱ for about 3 seconds until you hear one siren chirp and the LED turns on to
acknowledge program mode entry. The IntelliGuard 6000 is now in the “Feature Select” position for U
ser-Programmable Features.
5. Select the feature column: Press the unmarked button the same number of times as the column number. Pause. You will then hear
the same number of chirps as the column number you have selected, audibly confirming your selection .
6.Within five seconds, select the feature row: Press the
✱
button the same number of times as the feature’s row number. You’ll hear a
chirp each time you press the button to help you count.
7.If there is a NOTE for the selected feature, perform the actions noted.
8. Pause. You will hear either one or two chirps: two chirps = ON, one chirp = OFF.
9.You can select another feature, or you can exit program mode:
a. To select another feature in that same column, repeat step 6 within the next five seconds (after five seconds, three chirps
indicate that the IntelliGuard 6000 is now back in the “ Feature Select” position).
b. To select a different feature column, repeat step 5.
c. To exit program mode, turn the ignition off (you’ll hear three chirps and the LED will turn off to indicate exit of pro gram
mode), or wait 60 seconds and the IntelliGuard 6000 will automatically exit program mode.
It may sound a little complicated, but it really isn’t. Briefly, here is all you do: choose the feature you want to change, enter program
mode, select that feature’s column and row, wait for the on/off chirp confirmation, then turn off t he ignition. That’s it!
In tel liGuard 6000/1298 7