Filter
Top Products
Engine Bay Connections (Continued)
Hood Trigger
Vehicles with a ground-switching hood light will interface directly with the IntelliGuard 6000 (on positive switching vehicles, use a relay to
invert polarity). The switch may be located in or near the hood latch or at the hood light. If a s witch cannot be located, you must add a pin
switch in a location away from water channels.
1.Connect the GRAY/YELLOW wire to the hood switch.
Final Wiring Connections
1. Connect the RED wire to the 5A fuseholder as shown on page 2.
2.Connect the RED/WHITE wire to the 20A fuseholder as shown on page 2.
3. Attach the two fuseholders to the battery positive cable clamp.
4. Attach the BLACK wires to the vehicle battery negative cable clamp.
NOTE: Power and test ac ces so ries af ter the ba sic sys tem has been tested. In di vidu ally fuse all ac ces sory power
con nec tions. In di vidu ally fuse all +12V con nec tions.
SmartPowerUp™ 2
SmartPowerUp 2 ensures that the system powers up in the same state (disarmed, armed or valet mode) it was last in. When you first power
up the system, it will silently enter its disarmed state.
Delayed Courtesy Lights
Some vehicles have a courtesy light delay or dimming circuit, which interferes with an alarm being able to detect the door trigger upon
remote arming. If the delay or dimming lasts more than 5 seconds, no special connections or testing are needed, simply turn on the
Delayed
Courtesy Lights feature as noted in the Installer-Programmable Features section on page 9. Please note that since this feature sets the
system to arm the instant the courtesy lights are off, the Door Ajar Warning feature will not be av ailable.
Remote Control Channel Assignments
The IntelliGuard 6000 comes with two ergonomically designed remote controls: a master remote and a companion remote. Up to
two additional Clifford ACG 2 remote controls can be added (older Clifford ACG and non-ACG remotes are not compatible with
the IntelliGuard 6000). For instructions on how to use the remote controls, please refer to the ow ner’s manual.
Mas ter Re mote Control
In tel liGuard 6000/1298 5
Chan nel # Func tion Press but ton(s)
1 Arm/Disarm
2*
Activate Accessory*
(usually remote trunk release)*
3 Silent Arm/Disarm
+ ✱
4*
Activate Channel 4 Accessory*
(such as timed headlight activation)
5* IntelliStart 4 Accessory*
✱
6* SmartWindows 4 Accessory*
+
7* Remote Valet Mode Enter/Exit*
+ ✱
8* IntelliVoice 4 Accessory*
+
9* Unassigned*
+ ✱
10 Remote Piezo Sensor Override
+
*These channels can be assigned to control other Clifford ACG 2
systems and accessories on the customer’s other vehicles.