Filter
Top Products
Notice: If the jumper cables are connected or
removed in the wrong order, electrical shorting may
occur and damage the vehicle. The repairs would
not be covered by the vehicle warranty. Always
connect and remove the jumper cables in the
correct order, making sure that the cables do not
touch each other or other metal.
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine Part or Remote
Negative (−) Terminal
B. Good Battery or Remote Positive(+) and Remote
Negative (−) Terminals
C. Dead Battery or Remote Positive(+) Terminal
To disconnect the jumper cables from both vehicles,
do the following:
1. Disconnect the black negative(−) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative(−) cable from the
vehicle with the good battery.
3. Disconnect the red positive(+) cable from the
vehicle with the good battery.
4. Disconnect the red positive(+) cable from the
other vehicle.
All-Wheel Drive
All of the lubricant checks in this section apply to your
vehicle. If you have an all-wheel-drive vehicle, there is
an additional system that need lubrication.
Transfer Case
When to Check Lubricant
It is not necessary to regularly check the transfer case
fluid unless you suspect there is a leak or you hear an
unusual noise. A fluid loss could indicate a problem.
Have it inspected and repaired.
6-45