Bulldog Security 5002PRO Automobile Alarm User Manual


 
OPERATING INSTRUCTIONS
1. Arming
Press transmitter button #1 to arm the system. The siren
will chirp 1 time, the lights will flash once, the power
door locks will lock (if installed), and the LED will flash
slowly indicating the alarm is now armed. The engine starter
is also disabled.
2. Disarming
Pressing transmitter button #1 again will disarm the
system. The siren will chirp twice, the lights will
flash twice, and stay illuminated for 30 seconds,
acknowledging that the system is disarmed. NOTE: If you
hear 3 siren chirps and see 3 light flashes when
disarming, the vehicle was violated while you were away.
Check the LED for zone violation (See Operating
instructions #13 Zone Explanation). This is a good time
to check your vehicle for possible damage. Dome light
supervision (optional, must use relay) When disarming,
the dome light will turn on for 30 seconds.
3. Silent Arming/Disarming
Should you desire not to have the siren chirp when arming and disarming, press and hold transmitter
button #1 for 3 seconds. The system will perform all its usual arming/disarming functions, except there
will be no arming and disarming chirps. If the alarm is triggered, the siren will provide its normally
loud sound. NOTE: If the lights flash 3 times after disarming, the vehicle has been violated as described
in Operating Instructions #2.
4. Passive Automatic Arming Factory setting is off
To activate passive arming, disarm the system, then hold down button #3 for 10 seconds. The system
sill chirp once. Press button #3 again within 2 seconds. The system will chirp once to indicate the
system is now set to passive arming. To deactivate passive arming, repeat the above steps. You will
hear 2 chirps indicating passive arming is turned off.
5. Passive Arming With Door Locking Factory setting is off
To activate passive arming with door locking; disarm the system, then press and hold button #3 for 10
seconds. The system will chirp 1 time again. To deactivate passive arming with door locking; disarm
the system, then press and hold button #3 for 10 seconds. The system will chirp 1 time. Press button
#3 within 2 seconds and the system will now chirp twice.
6. High Theft Areas • Not available on 5002
There may be times when you have to park your car in areas that require an extra measure of protection.
This model can be programmed to emit a siren chirp every 30 seconds while the system is armed to warn
away potential thieves. To use this feature, press button #2 within 3 seconds after arming. The siren
will chirp 1 time indicating acceptance of this feature for this arming. The system will return to
normal operation after the system is disarmed.
7. Special Situations
There may be times when you have to reduce the shock sensor's sensitivity by 50% for this arming only,
press button #1 to arm and then again within 2 seconds after arming. To shut the sensor off completely
for this arming only, press button #1 twice within 2 seconds after arming. The next time you arm your
system, the shock sensor will return to the original setting.
8. Remote Car Starter Optional equipment required
A second channel built into this model can be activated while it is in the armed or disarmed mode.
The second channel can be used for remote engine starting, remotely popping the trunk, etc. Press
transmitter button #2 while the system is armed or disarmed, the parking lights will flash once, and
then will activate the installed accessory. As long as transmitter button #2 is pressed, a ground signal
is applied to the accessory. CAUTION: When remotely starting the vehicle while the system is armed,
shock and current sensing will shut off.
9. Car Finder
While the system is armed, press and release button #3. The alarm will chirp 6 times and the parking
lights will flash. This is used to locate your vehicle in a crowded parking lot.
10. Optional Accessories
Trunk Pop, etc., must use relays NOTE: When the alarm is disarmed, press button #4 and the trunk will
open. When the alarm is armed, press and hold button #3 for 2 seconds or until the trunk opens. CAUTION:
When opening the trunk while the system is armed, shock and current sensing will shut off.
1
3
2
4
BULLDOG
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
11