Autostart CT-5000 Remote Starter User Manual


 
CT-5000 Installation Guide P.29
Diagnostics - Parking Lights Flash Rate
Flashes Description
1
Doors locked, Starter Kill armed.
End of Run Time.
TRUNK button pressed
START signal received by the Module.
Cold Weather Mode cancelled.
Cannot start after maximum number of attempts is reached.
2
Run Time cancelled.
Remote start attempt cancelled by remote.
Doors unlocked, Starter Kill disarmed.
Exit remote valet
Exit ignition valet
3
Entering Cold Weather Mode
Enter remote valet
Enter ignition valet
4
+12 volts detected on the Brake line; cranking cancelled
Entering Tach Learning
5
New Transmitter learnt
Tach learnt
6
Remote start attempt was made with a Tach or a vacuum signal detected before
cranking
8
Unit reset: occurs when the unit is reset to factory defaults
10
The Hood Switch line went to ground during cranking or run time
1 – pause –
2
There was an attempt to start the vehicle while the Module was in Valet Mode.
2 – pause –
2
There was an attempt to start the vehicle while the Module was in Home Valet
Mode.
ON solid
Cold Weather Mode: the Brake Pedal is being held down
ON 2 sec.
The Hood is up and the Hood Switch line went to ground. This is step one of the
Programming Mode
ON 3 sec.
First press of the START/STOP button under Safe Start.
Entering Home Valet Mode
ON 4 sec.
LOCK or UNLOCK pulse (if door pulse is configured to 4 sec.)
ON 25 sec.
If the Hood Pin-switch has been pressed twice: the Unit went into step 1 of the
Programming cycle and no Transmitter activity was detected for 20 seconds
Or the Unit went into step 1 of the Transmitter Code Learning procedure and no
activity was detected for a few seconds. The Unit has exited the Transmitter Code
Learning procedure.
Irregular
If the Module gives irregular flashes (1 to 10 flashes followed by a pause, followed
by more flashes), it is in Playback Mode. This occurs when the Hood-switch line is
flashed 3 times.
Constant
flashes
up to 30 sec.
Panic Mode set off.