Filter
Top Products
P. 16 User Guide
How to Access Home Valet Mode
Function By pressing Icon Sound Instructions / description
To enter
Home Valet
Mode
Step 1 : or
Step 2 : +
simultaneously within 5 sec.
1 beep
Press or . Within 5 seconds, press
+ . . The transmitter will display
and there will be 1 beep.
To exit Home
Valet Mode
None None None
Insert key in ignition switch and turn to the
ON
position. The icon will disappear.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle (the unit will take over the vehicle and keep it running for 60 seconds or until it is
shut down by remote control). The vehicle will remain in Ready Mode.
If your vehicle has an automatic transmission
, proceed as follows to set the system in
Turbo Mode:
1. With the engine already running, release the brake pedal and press the , or
button on the transmitter until the parking lights come ON and you hear a series of clicks.
2. Remove the key from the ignition switch. The engine will continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the button (this will lock the doors; the engine will shut down after
60 seconds of Turbo Mode).
If your vehicle has a manual transmission
, follow all steps of the Ready Mode routine to
activate Turbo Mode:
1. Ensure that all doors, hood and trunk are closed and that the shifter is in the neutral
position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. of engaging the parking brake, press , or on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: The engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press and hold either:
a. to lock the doors and shut down the engine after 60 sec.;
b. to unlock the doors and shut down the engine after 60 sec.;
c. to shut down the engine immediately, without affecting the doors
(this will bypass Turbo Mode).
d. TO SET THE VEHICLE INTO IDLE MODE.
Engine Run Time
If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).