Filter
Top Products
P. 10 User Guide
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1. With the engine running, make sure to release the brake pedal and press the or
button (to unlock the doors) or the button on the remote control until the parking lights
come on or you hear a series of clicks.
2. Remove the key and exit the vehicle. The engine will continue running.
3. Lock the doors if needed.
The engine will continue running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine
as that used for Ready Mode; for the last step, the button is pressed instead of the other
buttons:
1. Ensure that all the doors, hood and trunk are closed and that the shifter is in the neutral
position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. of engaging the parking brake, press , or on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key; the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press the button until you hear a chirp (the doors will lock if remote door lock is
installed, and the system will arm).
If the pre-programmed run time expires or if the user shuts down the engine by remote
control, the vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle that is in Idle Mode.
Valet Modes
There are 3 sorts of Valet Modes: Combo Valet, Valet Start and Valet Alarm. When your vehicle is
in Combo Valet Mode, both the remote starter functions and the alarm functions are disabled.
When your vehicle is in Valet Start Mode, only the remote starter functions are disabled. When
your vehicle is in Valet Alarm Mode, only the alarm functions are disabled.
Combo Valet Mode
There are 3 different ways to get in and out of Combo Valet Mode:
1- Getting into Combo Valet Mode using the ignition key:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively
into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash three times and the LED on the antenna will remain ON solid to
indicate that the vehicle is now in Valet Mode.
• The icon will appear on your LCD remote.
1- Getting out of Combo Valet Mode using the ignition key:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times successively
into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash twice and the LED on the antenna will turn OFF to indicate that the
vehicle is now out of Valet Mode.
• The icon will disappear from your LCD remote.